Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)
RM2090E _58 Vehicle Interior _060696 DOOR LOCK _0297668 WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System) D

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)  DIAGNOSIS SYSTEM  



INSPECT BATTERY VOLTAGE


a.

Measure the battery voltage.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery.



SELF-DIAGNOSTIC MODE (OPERATING IGNITION KEY CYLINDER)


a.

Switch to self-diagnostic mode.

i.

Insert the key into the ignition key cylinder and remove it.


ii.

Within 5 seconds after the key is removed, insert it into the ignition key cylinder and then turn the ignition switch to ON then off once. (End in off)


iii.

Within 30 seconds after turning the ignition switch off, perform the following 9 times: Turn the ignition switch to ON then off. (End in off)

HINT:

Turning the ignition switch to ON after the procedure above has been completed will end the self-diagnostic mode.


NOTICE:

If the system fails to enter self-diagnostic mode, the system will return to normal mode.




b.
B220865E09
0.125,0.031 1.521,0.375 1.396,0.344 10 Interior Light Output: 0.625,1.396 0.854,1.615 0.229,0.219 10 ON 0.573,1.708 0.875,2 0.302,0.292 10 OFF 1.531,2.167 1.76,2.385 0.229,0.219 10 T1 2.146,2.167 2.406,2.406 0.26,0.24 10 T2 1.979,2.604 3.073,2.771 1.094,0.167 10 T1: 0.25 seconds 1.979,2.917 3.073,3.104 1.094,0.188 10 T2: 0.5 seconds 1.802,2.167 2.042,2.385 0.24,0.219 10 T1

Check that the system has switched to self-diagnostic mode by checking the interior light output pattern.


c.
B220865E08
0.125,0.031 2.396,0.375 2.271,0.344 10 Wireless Door Lock Buzzer Output: 0.635,1.406 0.865,1.552 0.229,0.146 10 ON 0.583,1.698 0.885,1.844 0.302,0.146 10 OFF 1.531,2.167 1.729,2.344 0.198,0.177 10 T1 2.146,2.167 2.344,2.344 0.198,0.177 10 T2 1.969,2.583 3.146,2.75 1.177,0.167 10 T1: 0.125 seconds 1.969,2.896 3.063,3.073 1.094,0.177 10 T2: 0.5 seconds 1.802,2.167 2,2.344 0.198,0.177 10 T1

Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern (w/ Wireless Door Lock Buzzer Answer-back Function).


d.

Check the diagnostic outputs when the door control transmitter module set sub-assembly switch is held down. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer* patterns.

*: w/ Wireless Door Lock Buzzer Answer-back Function


B466957E01
0.167,0.135 3.615,0.333 3.448,0.198 10 false Interior Light and Wireless Door Lock Buzzer*1 Output: 0.25,1.083 1.365,1.333 1.115,0.25 10 false Normal Wave 4.167,0.5 6.333,0.75 2.167,0.25 10 false Unmatching Recognition Code: 0.25,1.417 4,1.667 3.75,0.25 10 false (LOCK / UNLOCK / LUGGAGE OPEN / PANIC*2 Switch): 0.469,1.969 0.833,2.219 0.365,0.25 10 false ON 0.469,2.333 0.833,2.531 0.365,0.198 10 false OFF 4.219,1.146 4.583,1.396 0.365,0.25 10 false ON 4.219,1.552 4.583,1.75 0.365,0.198 10 false OFF 4.156,3.375 4.521,3.573 0.365,0.198 10 false OFF 5,2 6.75,2.25 1.75,0.25 10 false Wave is being received 1.219,2.833 1.583,3.083 0.365,0.25 10 false T1 1.719,2.833 2.083,3.031 0.365,0.198 10 false T2 4.167,2.917 6.333,3.167 2.167,0.25 10 false No Diagnostic Output: 0.417,3.083 4.167,3.333 3.75,0.25 10 false T1: 0.25 seconds (Interior Light) 0.667,3.417 4.417,3.667 3.75,0.25 10 false 0.125 seconds (Wireless Door Lock Buzzer)*1 0.417,3.75 4.167,4 3.75,0.25 10 false T2: 0.5 seconds (Interior Light) 0.667,4.083 4.417,4.333 3.75,0.25 10 false 0.25 seconds (Wireless Door Lock Buzzer)*1 0.333,4.417 4.083,4.667 3.75,0.25 10 false *1: w/ Wireless Door Lock Buzzer Answer-back Function 4.75,4.417 7.01,4.667 2.26,0.25 10 false *2: w/ Panic Alarm Control Function