| Component | Outline |
|---|---|
| Engine switch | ·
Turns on the power and starts the engine. ·
Contains a built-in transponder key amplifier to start the engine when the key does not operate properly due to a depleted battery or wave interference. |
| Certification ECU (smart key ECU assembly) | ·
Performs key verification. ·
Controls the electrical key antenna (outside), electrical key antenna (indoor) and door lock/unlock sensor. ·
Receives the open signal from the back door opener switch assembly and outputs a signal to the main body ECU (network gateway ECU) via CAN communication. ·
Outputs entry door lock/unlock commands. ·
Outputs steering lock actuator assembly lock/unlock command signals. ·
Outputs immobiliser set/unset commands. ·
Controls the theft warning indicator light. ·
Controls the entry key indicator light in the combination meter assembly. ·
Changes the power source mode by operating the ACC and IG relays. ·
Forms the entry detection area. |
| ID code box (immobiliser code ECU)*1 | ·
Receives command signals from the certification ECU (smart key ECU assembly) and outputs immobiliser set and unset command signals to the ECM. ·
Records codes for verification. |
| ECM | ·
Outputs a signal indicating that the engine has started to the certification ECU (smart key ECU assembly) when starting the engine. ·
Controls starting by operating the starter relay. |
| Steering lock actuator assembly (steering lock ECU) | ·
Receives command signals from the certification ECU (smart key ECU assembly) and activates the steering lock actuator assembly. ·
Records codes for verification. |
| Combination meter assembly | ·
Operates various warnings (sounding of the buzzer in the combination meter) according to the command signals from the certification ECU (smart key ECU assembly). ·
Notifies the user when the entry and start system has a malfunction. |
| Brake Actuator Assembly (Skid Control ECU) | Outputs a vehicle speed signal to the certification ECU (smart key ECU assembly). |
| IG, ACC relay | Turns on/off according to certification ECU (smart key ECU assembly) control and provides power to each system. |
| Stop light switch assembly*2 | Detects that the brake pedal has been depressed (switch is on) and outputs a signal to the certification ECU (smart key ECU assembly). |
| Clutch start switch assembly*3 | Detects that the clutch pedal has been depressed (switch is on) and outputs a signal to the certification ECU (smart key ECU assembly). |
| Park/neutral position switch assembly*2 | Outputs the shift position to the certification ECU (smart key ECU assembly) |
| Shift lock control ECU*2 | Outputs a shift lock control ECU signal to the certification ECU (smart key ECU assembly). |
| Indoor electrical key oscillator (front floor)
No. 2 indoor electrical key oscillator (rear floor) |
Sends the request code from the certification ECU (smart key ECU assembly) and forms the vehicle interior detection area. |
| Door control receiver | Receives the entry and start system code / wireless code sent from the key and sends it to the certification ECU (smart key ECU assembly). |
| Electrical key transmitter sub-assembly | Sends the ID code upon receiving a request signal. |
*1: w/ ID Code Box
*2: for Automatic Transmission
*3: for Manual Transmission