Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System)
RM2090E _58 Vehicle Interior _060697 THEFT DETERRENT / KEYLESS ENTRY _0297682 ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System)  B1577  Immobiliser System EEPROM Malfunction  


DESCRIPTION

The ECM stores this code when an internal malfunction is detected in the certification ECU (smart key ECU assembly) or when the ROM in the certification ECU (smart key ECU assembly) cannot be accessed.

DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation
B1577
·

Internal malfunction in the certification ECU (smart key ECU assembly) (1 trip detection logic*).

·

When the ROM in the certification ECU (smart key ECU assembly) cannot be accessed (1 trip detection logic*).


Certification ECU (smart key ECU assembly) Check for DTCs.

*: Only output while a malfunction is present.


Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Engine cannot be started Engine switch on (IG)

Related Data List and Active Test
DTC Code Data List and Active Test
B1577 -

CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the certification ECU (smart key ECU assembly), refer to the entry and start system (for Entry Function) (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>PRECAUTION).

·

After repair, confirm that no DTCs are output by performing the "DTC Output Confirmation Operation".



PROCEDURE

2.CHECK FOR DTC

OK

END

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)