Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM
RM2090E _58 Vehicle Interior _060698 LIGHTING (INT) _0297690 LIGHTING SYSTEM A

LIGHTING (INT)  LIGHTING SYSTEM  CUSTOMIZE PARAMETERS  


PROCEDURE

Hide 1.CUSTOMIZE LIGHTING SYSTEM (INT)

a.

Customizing using the GTS

HINT:

The following items can be customized.


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Customize Setting / Illuminated Entry.


v.

Select the setting by referring to the table below.

Illuminated Entry
Tester Display Default Content Setting Relevant ECU
Lighting Time 15 s Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the ignition switch from off to ACC or ON.) 7.5 s, 15 s or 30 s Main body ECU (Network gateway ECU)
I/L when ACC OFF ON Lights up the engine switch illumination*1, ignition key cylinder light*2 and map light when the ignition switch is turned from ACC or ON to off. ON or OFF
I/L ON W/Door Key Unlock ON Lights up the engine switch illumination*1, ignition key cylinder light*2 and map light when doors are unlocked using a mechanical key or door control transmitter. ON or OFF
Room Light when Aprchd*1 ON Lights up the engine switch illumination and map light when a key enters any actuation area around the doors. ON or OFF
Interior Light Control ON Lights up the engine switch illumination*1, ignition key cylinder light*2 and map light when the illuminated entry function is operating. ON or OFF

*1: w/ Entry and Start System

*2: w/o Entry and Start System