Use the same procedure for the RH and LH sides.
The procedure described below is for the RH side.
74310
1.REMOVE VISOR ASSEMBLY
Remove the 2 screws.
Disengage the visor assembly from the visor holder.
Disconnect the connector and remove the visor assembly.
81341
2.REMOVE VANITY LIGHT LENS
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the vanity light lens.
| *1 | Protective Tape |
81340B
3.REMOVE VANITY LIGHT BULB
Remove the vanity light bulb from the visor assembly.