The combination meter communicates with the ECM, skid control ECU (brake actuator assembly), power steering ECU assembly, main body ECU (network gateway ECU) and airbag sensor assembly via the CAN communication system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0073 | Lost Communication with Each ECU | CAN communication system |
| U0100 | ECM communication error | ·
CAN communication system ·
ECM |
| U0122 | Skid control ECU (brake actuator assembly) communication error | ·
CAN communication system ·
Skid control ECU (brake actuator assembly) |
| U0131 | Power steering ECU assembly communication error | ·
CAN communication system ·
Power steering ECU assembly |
| U0140 | Main body ECU (network gateway ECU) communication error | ·
CAN communication system ·
Main body ECU (network gateway ECU) |
| U0151 | Airbag sensor assembly communication error | ·
CAN communication system ·
Airbag sensor assembly |
Check DTC (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| CAN communication DTC is not output | A |
| CAN communication DTC is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)