The airbag ECU assembly consists of the deceleration sensor, drive circuit, diagnosis circuit, ignition control, etc.
If the airbag ECU assembly receives signals from the deceleration sensor, it determines whether the airbag squib and pretensioner squib should be activated.
DTC B1000 is stored when a malfunction is detected in the airbag ECU assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1000 | Airbag ECU assembly malfunction | Airbag ECU assembly |
Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1000 is output | A |
| DTC B1000 and other DTCs are output | B |
If only DTC B1000 is output, do not clear the DTCs, replace the airbag ECU assembly.
If any DTCs other than DTC B1000 are also output, troubleshoot those DTCs first.
A
B
(See pageVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)