The side collision sensor LH circuit (to determine deployment of the front seat airbag assembly LH, curtain shield airbag assembly LH and front seat outer belt assembly LH) is composed of the airbag ECU assembly, side airbag sensor assembly LH, side No. 2 airbag sensor assembly LH and rear airbag sensor LH and No. 2 airbag sensor assembly.
The side No. 2 airbag sensor assembly LH detects impacts to the vehicle and sends signals to the airbag ECU assembly to determine if the airbag should be deployed.
These DTCs are stored when a malfunction is detected in the side No. 2 airbag sensor assembly LH.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1625 | ·
Side No. 2 airbag sensor assembly LH malfunction ·
Airbag ECU assembly malfunction |
·
Side No. 2 airbag sensor assembly LH ·
Airbag ECU assembly |
| B16F5 | ·
Improper installation of side No. 2 airbag sensor assembly LH ·
Airbag ECU assembly malfunction |
Refer to DTCs B1627, B1628, B1637, B1638, B1647, B1697 and B1698 (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>B1627).
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Interchange the side No. 2 airbag sensor assembly LH with RH and connect the connectors.
Connect the cable to the negative (-) battery terminal.
Clear the DTCs stored in memory (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1625 is output. | A |
| DTC B1620 is output. | B |
| DTCs B1620 and B1625 are not output. | C |
Codes other than DTCs B1620 and B1625 may be output at this time, but they are not related to this check.
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Return the side No. 2 airbag sensor assembly LH and RH to their original positions and connect the connectors.
| *1 | Side No. 2 Airbag Sensor Assembly RH |
| *2 | Airbag ECU Assembly |
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)