Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR FLOOR AIRBAG SENSOR
RM2090E _58 Vehicle Interior _060701 SUPPLEMENTAL RESTRAINT SYSTEMS _0297716 REAR FLOOR AIRBAG SENSOR G

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR FLOOR AIRBAG SENSOR  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the rear floor side airbag sensor.


PROCEDURE

Hide 89970 1.CHECK NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)

Hide 89970 2.CHECK NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)


b.

Visually check for defects with the No. 2 airbag sensor assembly installed on the vehicle.

HINT:

The defects are as follows:


·

Cracks on the sensor housing

·

Dents on the sensor housing

·

Chips on the sensor housing

·

Cracks or other damage to the connector

·

Damage to the serial number


OK:

No defects are found.


If any of the defects is found, replace the No. 2 airbag sensor assembly with a new one.


Hide 89970 3.CHECK NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)

a.

When front seat airbags or curtain shield airbags have deployed as the result of a collision, be sure to replace No. 2 airbag sensor assembly.


b.

Visually check the No. 2 airbag sensor assembly in undamaged areas for defects.

HINT:

The defects are as follows:


·

Cracks on the sensor housing

·

Dents on the sensor housing

·

Chips on the sensor housing

·

Cracks or other damage to the connector

·

Damage to the serial number


OK:

No defects are found.


If any of the defects is found, replace the No. 2 airbag sensor assembly with a new one.