Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
72526A
1.REMOVE RECLINING ADJUSTER RELEASE HANDLE
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the reclining adjuster release handle.
| *1 | Protective Tape |
72493
2.REMOVE VERTICAL ADJUSTING HANDLE (for Driver Side)
Remove the screw and vertical adjusting handle.
3.REMOVE SEAT ADJUSTER COVER CAP
Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws to remove the seat adjuster cover cap.
| *1 | Protective Tape |
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD
Remove the 2 screws.
Disengage the 4 claws, 5 guides and clip to remove the front seat cushion shield.
71862
5.REMOVE FRONT SEAT INNER CUSHION SHIELD
Disengage the 2 claws and 4 guides to remove the front seat inner cushion shield.
73240
6.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
73230
7.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
8.REMOVE SEAT LOCK BAND ASSEMBLY (for Fold Down Seat Type)
Remove the screw and seat lock band assembly.
9.REMOVE SEAT TRACK CONTROL CABLE ASSEMBLY (for Walk in Seat Type)
Disengage the 2 claws to disconnect the seat track control cable assembly.
Remove the seat track control cable assembly as shown in the illustration.
Be careful not to damage the seat track control cable assembly.
10.REMOVE SEAT TRACK CABLE BRACKET (for Walk in Seat Type)
Remove the washer and seat track cable bracket.
11.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Disengage the 2 hooks.
Disconnect the rubber band of the separate type front seatback cover.
Disconnect the front seat heater connector and disengage the clamp. (w/ Seat Heater System)
Disengage the fastener and separate the front seat airbag assembly wire harness.
Disengage the claw and 4 clamps to separate the front seat airbag assembly wire harness.
Remove the washer (for Fold Down Seat Type).
Using a T40 "TORX" socket wrench, remove the 4 bolts, separate type front seatback assembly and No. 2 front seat travel link.
12.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Remove the 5 hog rings.
Open the 2 fasteners.
Turn back the separate type front seatback cover.
Remove the 2 hog rings.
Disengage the 2 hooks.
Remove the nut and the 3 brackets.
Disengage the 4 claws and remove the 2 front seat headrest supports.
Remove the separate type front seatback cover with pad from separate type front seatback spring assembly.
73920A
13.REMOVE FRONT SEAT AIRBAG ASSEMBLY
71074S
14.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Remove the 14 hog rings and separate type front seatback cover from the separate type front seatback pad.
Remove the 7 front seatback cover wires from the separate type front seatback cover.
15.REMOVE NO. 2 FRONT SEATBACK HOOK
Disengage the 2 claws to remove the 2 No. 2 front seatback hooks from the separate type front seatback spring assembly.
16.REMOVE FRONT SEATBACK SPRING SUB-ASSEMBLY
Disengage the 2 claws and 2 hooks to remove the front seatback spring sub-assembly from the separate type front seatback spring assembly.
17.REMOVE NO. 1 FRONT SEATBACK HOOK
Remove the 2 No. 1 front seatback hooks from the front seatback spring sub-assembly.
18.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Disconnect the occupant detection sensor connector. (for Front Passenger side)
Disengage the claw and 3 clamps to separate the front seat heater wire harness. (w/ Seat Heater System)
Disengage each hook and remove the separate type front seat cushion cover with pad from separate type front seat cushion spring assembly. (for Driver Side)
Disengage each hook and remove the separate type front seat cushion cover with pad from separate type front seat cushion spring assembly. (for Front Passenger Side)
71072S
19.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the 2 hog rings.
Remove the 12 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad.
Remove the 4 front seat cushion cover wires from the separate type front seat cushion cover.
71874
20.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH (for Driver Side)
Remove the screw.
Disengage the hook.
Disengage the clip and remove the front seat lower cushion shield LH.
71873
21.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH (for Driver Side)
Use the same procedure as for the LH side.
71538B
22.REMOVE LH SEAT FRONT SEAT CUSHION EDGE PROTECTOR LH
Remove the screw.
Disengage the 3 claws to remove the LH seat front seat cushion edge protector LH.
71537H
23.REMOVE LH SEAT FRONT SEAT CUSHION EDGE PROTECTOR RH
Use the same procedure as for the LH side.
72211
24.REMOVE SEAT TRACK ADJUSTING HANDLE
Using a screwdriver, disengage the 2 springs to remove the seat track adjusting handle from separate type front seat cushion spring assembly.
25.REMOVE NO. 1 FRONT SEAT CUSHION PROTECTOR (for Driver Side)
Disengage the claw to remove the No. 1 front seat cushion protector from the separate type front seat cushion spring assembly.
26.REMOVE NO. 2 FRONT SEAT CUSHION PROTECTOR (w/o Seat Heater System)
Disengage the claw to remove the No. 2 front seat cushion protector from the separate type front seat cushion spring assembly.
27.REMOVE FRONT SEAT CUSHION SPRING
Disengage the 8 hooks to remove the front seat cushion spring from the separate type front seat cushion spring assembly.