Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR
RM2090E _58 Vehicle Interior _060703 SEAT BELT _0297733 OCCUPANT DETECTION SENSOR A

SEAT BELT  OCCUPANT DETECTION SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the front passenger side of RHD and LHD vehicles.

·

The procedures listed below are for the front passenger side of an LHD vehicle.



PROCEDURE

Hide 1.INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR)

a.
B299986E01
0.358,2.657 0.514,2.838 0.156,0.181 10 *1 2.107,3.031 2.263,3.212 0.156,0.181 10 *2 0.716,2.882 0.542,2.758 false 1.702,3.748 2.077,3.169 false

Using hog ring pliers, install the separate type front seat cushion pad to the separate type front seat cushion cover with 12 new hog rings.

NOTICE:
·

Be careful not to damage the separate type front seat cushion cover.

·

When installing the hog rings, take care to minimize wrinkles as much as possible.



Text in Illustration
*1 Hog Ring
*2 Hog Ring Pliers


b.
B279525E01
1.12,2.602 1.345,2.827 0.225,0.225 10 *1 0.903,2.89 1.12,2.713 false 2.023,3.094 2.248,3.320 0.225,0.225 10 *2 1.525,3.812 2.023,3.206 false

Using hog ring pliers, install 2 new hog rings.

NOTICE:
·

Be careful not to damage the separate type front seat cushion cover.

·

When installing the hog rings, take care to minimize wrinkles as much as possible.



Text in Illustration
*1 Hog Ring
*2 Hog Ring Pliers


Hide 2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

HINT:

Use the same procedure as for the driver seat (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY>INSTALLATION).