87138C
1.INSPECT BLOWER RESISTOR
Disconnect the connector from the blower resistor.
| *a | Component without harness connected
(Blower Resistor) |
There is a fuse between terminals 1 and 3.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 4 | Always | 2.92 Ω |
| 1 - 3 | Always | 0.44 Ω |
| 1 - 2 | Always | 1.12 Ω |
If the resistance is not as specified, replace the blower resistor.