1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
55312
3.REMOVE LOWER INSTRUMENT PANEL (for LHD)
55607
4.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
88625Q
5.REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR (for RHD)
Disengage the 2 claws and remove the cooler (room temp. sensor) thermistor.
88625Q
6.REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR (for LHD)
Use the same procedure described for the RHD.