89120A
1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR
Disconnect the connector from the automatic light control sensor.
| *a | Component with harness connected
(automatic light control sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1(TSD) - 6(CLTE) | Solar sensor covered with a cloth. | Below 0.8V |
| Solar sensor exposed to electric light. | 4.0 to 4.6V |
Use an incandescent light for inspection. Bring it within about 30 cm (11.8 in.) of the automatic light control sensor.
If the resistance is not as specified, replace the automatic light control sensor.