1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
55981
3.SEPARATE NO. 1 DEFROSTER NOZZLE GARNISH
Using a moulding remover, separate the 3 claws as shown in the illustration.
| *1 | Moulding Remover |
89120A
4.REMOVE AUTOMATIC LIGHT CONTROL SENSOR
Disconnect the connector.
Disengage the 2 claws and remove the automatic light control sensor.