Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM2090E _59 Vehicle Exterior _060708 DOOR / HATCH _0297768 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B227882E01
2.429,0 2.613,0.170 0.184,0.170 10 *2 0.711,0 0.894,0.170 0.184,0.170 10 *1

HINT:
·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.

·

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

Specified torque for standard bolts is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



Text in Illustration
*1 Centering Bolt
*2 Standard Bolt

PROCEDURE

Hide 53301 2.ADJUST HOOD SUB-ASSEMBLY

a.

Horizontally and vertically adjust the hood.

i.
B312163

Loosen the 4 hinge bolts of the hood.


ii.

Adjust the clearance between the hood and front fender by moving the hood.


iii.

Tighten the 4 hinge bolts after the adjustment.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)



b.

Adjust the height of the front end of the hood using the cushion rubbers.

i.
B312164

Adjust the 2 cushion rubbers so that the heights of the hood and fender are aligned.

HINT:

Raise or lower the front end of the hood by turning the 2 cushion rubbers.




c.

Adjust the hood lock.

i.

Loosen the 3 bolts.


ii.
B314955

Adjust the hood lock position so that the striker can enter it smoothly.


iii.
B313112E02
2.639,0.828 2.739,0.983 0.100,0.155 10 1 1.818,1.8 1.918,1.955 0.100,0.155 10 2 0.973,0.848 1.073,1.003 0.100,0.155 10 3

Tighten the 3 bolts after the adjustment in the order shown in the illustration.

Torque:
33 N*m (337 kgf*cm, 24 ft.*lbf)


iv.

Check that the striker can engage smoothly with the hood lock.