Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR
RM2090E _59 Vehicle Exterior _060708 DOOR / HATCH _0297772 LUGGAGE COMPARTMENT DOOR N

DOOR / HATCH  LUGGAGE COMPARTMENT DOOR  ADJUSTMENT  


CAUTION / NOTICE / HINT

B146067E02
2.55,1.759 2.774,1.912 0.224,0.153 10 *2 0.642,1.759 0.866,1.912 0.224,0.153 10 *1

HINT:
·

Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



Text in Illustration
*1 Centering Bolt
*2 Standard Bolt

PROCEDURE

Hide 64401 1.INSPECT LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY

a.

Check that the clearance measurements of areas *a to *f are within each standard range.

B310904E01
0.765,1.397 0.923,1.548 0.158,0.151 10 *a 6.478,1.779 6.636,1.930 0.158,0.151 10 *d 3.661,1.642 3.819,1.793 0.158,0.151 10 *c 2.831,1.018 2.988,1.169 0.158,0.151 10 *b 4.438,4.343 4.596,4.494 0.158,0.151 10 *e 3.82,4.47 3.978,4.621 0.158,0.151 10 *f

Standard Clearance:
Area Measurement Area Measurement
*a 8.2 mm (0.3228 in.) *b 2.0 to 5.0 mm (0.0787 to 0.1969 in.)
*c -2.0 to 1.0 mm (-0.0787 to 0.0394 in.) *d 5.8 to 10.2 mm (0.2283 to 0.4016 in.)
*e 4.3 to 7.3 mm (0.1693 to 0.2874 in.) *f -2.0 to 1.0 mm (-0.0787 to 0.0394 in.)



Hide 64401 2.ADJUST LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY

a.
B310950

Horizontally and vertically adjust the door by loosening the door side hinge bolts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


b.
B310951

When adjusting the rear edge of the doors left or right, or adjusting the luggage door closer assembly, loosen the bolts before making adjustments.


c.

Using a brass bar and a hammer, hit the striker to adjust its position.


d.

After the adjustment, tighten the 2 bolts on the luggage door closer assembly.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)