Use the same procedure for the LHD and RHD vehicles.
84840D
1.INSPECT LUGGAGE DOOR OPENING SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 4 - 1 | Pushed (ON) | Below 1 Ω |
| 4 - 1 | Not pushed (OFF) | 10 kΩ or higher |
| *a | Component without harness connected
(Luggage Door Opening Switch Assembly) |
If the result is not as specified, replace the switch assembly.