Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR OPENER SYSTEM
RM2090E _59 Vehicle Exterior _060708 DOOR / HATCH _0297778 LUGGAGE COMPARTMENT DOOR OPENER SYSTEM U

DOOR / HATCH  LUGGAGE COMPARTMENT DOOR OPENER SYSTEM  TERMINALS OF ECU  


CHECK MAIN BODY ECU (NETWORK GATEWAY ECU)


U146880E05
0.313,0.292 0.531,0.5 0.219,0.208 10 false *1 1.656,6.792 1.885,7 0.229,0.208 10 false *2 0.49,1.24 0.896,1.479 0.406,0.24 10 false 3D 0.479,1.865 0.885,2.104 0.406,0.24 10 false 3C 0.479,2.406 0.885,2.646 0.406,0.24 10 false 3E 3.729,1.052 4.135,1.292 0.406,0.24 10 false MB 3.479,3.219 3.885,3.458 0.406,0.24 10 false MB 6.323,1.229 6.729,1.469 0.406,0.24 10 false 3B 6.333,1.865 6.74,2.104 0.406,0.24 10 false 3A 1.469,4.083 1.875,4.323 0.406,0.24 10 false 3D 4.177,4.083 4.583,4.323 0.406,0.24 10 false 3C 4.906,5.292 5.313,5.531 0.406,0.24 10 false 3A 3.052,6.552 3.458,6.792 0.406,0.24 10 false A73 3.677,6.552 4.01,6.792 0.333,0.24 10 false D5 4.25,6.552 4.583,6.792 0.333,0.24 10 false D6 1.802,5.292 2.208,5.531 0.406,0.24 10 false 3B 6.25,4.083 6.656,4.323 0.406,0.24 10 false 3E 1.167,7.531 1.573,7.771 0.406,0.24 10 false A73 3.563,7.521 3.896,7.76 0.333,0.24 10 false D5 5.875,7.531 6.208,7.771 0.333,0.24 10 false D6

Text in Illustration
*1 Instrument Panel Junction Block Assembly *2 Main Body ECU (Network Gateway ECU)

a.

Remove the main body ECU (network gateway ECU) from the instrument panel junction block assembly.


b.

Disconnect the D5* and D6 main body ECU (network gateway ECU) connectors.


c.

Measure the resistance and voltage according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
D5-27 - Body ground* G - Body ground Luggage door opening cancel switch signal input Luggage door opening cancel switch assembly off 10 kΩ or higher
Luggage door opening cancel switch assembly on Below 1 Ω
D6-16 (TSW) - Body ground L - Body ground Luggage door opening switch signal input Luggage door opening switch assembly off 10 kΩ or higher
Luggage door opening switch assembly on Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.


d.

Reconnect the D5* and D6 main body ECU (network gateway ECU) connectors.


e.

Install the main body ECU (network gateway ECU) to the instrument panel junction block assembly.


f.

Measure the voltage according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
D5-27 - Body ground* G - Body ground Luggage compartment door lock motor drive output Ignition switch ON
Luggage door opening cancel switch on
Below 1 V
D6-16 (TSW) - Body ground L - Body ground Luggage compartment door lock motor drive output Ignition switch ON
Luggage door opening switch on
Below 1 V
3B-6 - Body ground G - Body ground Luggage compartment door lock motor drive output Ignition switch ON
Luggage door opening switch on
11 to 14 V

If the result is not as specified, the main body ECU (network gateway ECU) or instrument panel junction block assembly may have a malfunction.



*: w/ Side Marker Light