1.INSPECT MIR HTR RELAY
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
| *a | Component without harness connected
(MIR HTR Relay) |
If the result is not as specified, replace the MIR HTR relay.