Ensure that fingers or articles of clothing do not get caught by moving parts when performing this test.
85110
1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)
Check the LO operation.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 5 (+1)
Battery negative (-) → Terminal 4 (E) |
Motor operates at low speed (LO) |
If the result is not as specified, replace the windshield wiper motor assembly.
Check the HI operation.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 3 (+2)
Battery negative (-) → Terminal 4 (E) |
Motor operates at high speed (HI) |
If the result is not as specified, replace the windshield wiper motor assembly.
| *a | Component without harness connected
(Windshield Wiper Motor Assembly) |
85110
2.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)
Check the LO operation.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 1 (+1)
Battery negative (-) → Terminal 5 (E) |
Motor operates at low speed (LO) |
If the result is not as specified, replace the windshield wiper motor assembly.
Check the HI operation.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 (+2)
Battery negative (-) → Terminal 5 (E) |
Motor operates at high speed (HI) |
If the result is not as specified, replace the windshield wiper motor assembly.
| *a | Component without harness connected
(Windshield Wiper Motor Assembly) |