Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
85110
1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
for LH Side
Operate the windshield wiper motor assembly.
Stop the windshield wiper motor assembly operation.
Check the automatic stop (park) position.
| Area | Standard Condition |
|---|---|
| a | 35.0 mm (1.378 in.) |
| *1 | Ceramic Dot |
| *2 | Cowl Panel End |
After the front wiper motor stops, check the automatic stop position after lifting the wiper blade 2 times.
The front wipers stop at the positions shown in the illustration.
for RH Side
Operate the windshield wiper motor assembly.
Stop the windshield wiper motor assembly operation.
Check the automatic stop (park) position.
| Area | Standard Condition |
|---|---|
| a | 33.0 mm (1.299 in.) |
| *1 | Ceramic Dot |
| *2 | Cowl Panel End |
After the front wiper motor stops, check the automatic stop position after lifting the wiper blade 2 times.
The front wipers stop at the positions shown in the illustration.