Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER CONTROL RELAY
RM2090E _59 Vehicle Exterior _060710 WIPER / WASHER _0297793 HEADLIGHT CLEANER CONTROL RELAY G

WIPER / WASHER  HEADLIGHT CLEANER CONTROL RELAY  INSPECTION  


PROCEDURE

Hide 85942 1.INSPECT HEADLIGHT CLEANER CONTROL RELAY

E186708E15
1.667,1.448 1.667,1.792 true 1.302,1.469 1.177,1.813 true 2.031,1.469 2.177,1.833 true 1.656,0.448 1.656,0.823 true 2,0.448 1.958,0.833 true 1.25,0.438 1.302,0.833 true 1.208,0.229 1.344,0.385 0.135,0.156 10 false H 1.635,1.833 1.76,2.01 0.125,0.177 10 false E 1.948,0.24 2.156,0.417 0.208,0.177 10 false IG 1.552,0.24 1.781,0.396 0.229,0.156 10 false PB 0.958,1.833 1.448,2 0.49,0.167 10 false WRWA 2.073,1.844 2.344,2 0.271,0.156 10 false WF 0.156,0.177 0.323,0.365 0.167,0.188 10 false *a

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (WRWA) - 4 (WF) Battery voltage not applied 10 kΩ or higher
Battery positive (+) → 3 (H)
Battery negative (-) → 4 (WF)
Battery negative (-) → 5 (E)
Battery positive (+) → 3 (H)
Battery negative (-) → 2 (PB)
Battery negative (-) → 4 (WF)
Below 1 Ω for 0.6 to 1.0 seconds, then resistance increases by a large amount
Battery positive (+) → 3 (H)
Battery negative (-) → 1 (IG)
Battery negative (-) → 4 (WF)
Battery negative (-) → 5 (E)


Text in Illustration
*a Component without harness connected
(Headlight Cleaner Control Relay)

If the result is not as specified, replace the headlight cleaner switch assembly.