Home › Vehicle Exterior › LIGHTING (EXT) › HIGH INTENSITY DISCHARGE HEADLIGHT BULB
RM2090E _59 Vehicle Exterior _060711 LIGHTING (EXT) _0297797 HIGH INTENSITY DISCHARGE HEADLIGHT BULB A

LIGHTING (EXT)  HIGH INTENSITY DISCHARGE HEADLIGHT BULB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 81189 3.REMOVE HEADLIGHT COVER

a.
B312205

Turn the headlight cover in the direction indicated by the arrow shown in the illustration, and remove it.


Hide 81110L 4.REMOVE DISCHARGE HEADLIGHT BULB

a.
B312196

Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration and disconnect the headlight light control ECU sub-assembly socket.


b.
B312206E02
1.167,0.542 1.292,0.75 0.125,0.208 10 true 1 1.177,1.104 1.302,1.292 0.125,0.188 10 true 2 1.875,0.521 2.021,0.719 0.146,0.198 10 true 1

Release the set spring as indicated by the arrow in the order shown in the illustration.


c.

Remove the discharge headlight bulb.

NOTICE:

Do not touch the glass part of the bulb.