Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
81740
1.INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY
Connect the connector.
Engage the claw to install the side turn signal light assembly.
Check that the side turn signal light assembly is installed securely.
If the side turn signal light assembly is not installed securely, widen and adjust the claw.
| Area | Specified Condition |
|---|---|
| a | 3.0 mm (0.118 in.) |
| *1 | Side Turn Signal Light Assembly |
| *2 | Claw |
53876A
2.INSTALL FRONT FENDER LINER LH
Install the fender liner with the 4 clips.