Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
53876A
1.SEPARATE FRONT FENDER LINER LH
Steer the front tire right most.
Remove the 4 clips and partially remove the front fender liner.
81740
2.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY
Using a screwdriver wrapped with protective tape, disengage the claw from service hole.
| *1 | Protective Tape |
| *2 | Service Hole |
Insert screwdriver on the level.
Disconnect the connector to remove the side turn signal light assembly.