Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY › from 2016.06
RM2090E _59 Vehicle Exterior _060711 LIGHTING (EXT) _0297803 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR COMBINATION LIGHT ASSEMBLY

a.

Engage the guide to temporarily install the rear combination light assembly.


b.
E356556E01
0.625,0.469 0.969,0.771 0.344,0.302 10 false (1) 0.385,1.5 0.729,1.802 0.344,0.302 10 false (4) 2.292,1.844 2.635,2.146 0.344,0.302 10 false (3) 1.99,0.427 2.333,0.729 0.344,0.302 10 false (2)

Tighten the 4 nuts in the order shown in the illustration to install the rear combination light assembly.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


c.

Engage the 2 grommets to connect the rear combination light socket and wire sub-assembly.


d.

Connect the connector.


Hide 64722 2.INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH (w/ Side Marker Light)

Hide 64722 3.INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH (w/o Side Marker Light)

a.

Install the luggage compartment inner trim cover LH with the 5 clips.


Hide 58387 4.INSTALL REAR FLOOR FINISH PLATE

a.

Engage the 4 claws to install the rear floor finish plate.


b.

Install the 3 clips.


Hide 64711 5.INSTALL LUGGAGE COMPARTMENT FLOOR MAT