Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
81565
1.INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (w/o Side Marker Light)
Apply battery voltage to the connector and check the light comes on.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → 1 (B)
Battery negative (-) → 2 (E) |
Turn signal light comes on |
| Battery positive (+) → 3 (STP)
Battery negative (-) → 2 (E) |
Stop light comes on |
| Battery positive (+) → 4 (TL)
Battery negative (-) → 2 (E) |
Tail light comes on |
| *a | Component without harness connected
(Rear Combination Light Socket and Wire Sub-assembly) |
If the result is not as specified, replace the bulb or the rear combination light socket and wire sub-assembly.
81565
2.INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (w/ Side Marker Light)
Apply battery voltage to the connector and check the light comes on.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (B)
Battery negative (-) → 2 (E) |
Turn signal light comes on |
| Battery positive (+) → 3 (STP)
Battery negative (-) → 2 (E) |
Stop light comes on |
| Battery positive (+) → 1 (TL)
Battery negative (-) → 2 (E) |
Tail and Side marker light comes on |
| *a | Component without harness connected
(Rear Combination Light Socket and Wire Sub-assembly) |
If the result is not as specified, replace the bulb or the rear combination light socket and wire sub-assembly.