Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY › 2012.03–2016.06
RM2090E _59 Vehicle Exterior _060711 LIGHTING (EXT) _0297803 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 81562A 1.REMOVE REAR COMBINATION LIGHT GASKET LH

a.
B370948

Remove the rear combination light gasket LH.

NOTICE:
·

Be sure to remove all the traces of the old rear combination light gasket from the rear combination light lens and body LH.

·

Do not reuse the removed packing. Be sure to install a new rear combination light gasket to prevent water ingress.




Hide 81550L 2.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
B312222

Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.


b.

Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.


Hide 81550S 3.REMOVE REAR SIDE MARKER LIGHT BULB (w/ Side Marker Light)

a.
B314900

Turn the rear combination light socket and wire sub-assembly with the rear side marker light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.


b.

Remove the rear side marker light bulb from the rear combination light socket and wire sub-assembly.


Hide 81565 4.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY

a.
B312223

Disengage the clamp.


b.

Disconnect the connector.


c.
B312224

Disengage the 2 clamps to remove the rear combination light socket and wire sub-assembly.