Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY › 2012.03–2016.06
RM2090E _59 Vehicle Exterior _060711 LIGHTING (EXT) _0297803 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 81565 1.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY

a.
B312224

Engage the 2 clamps to install the rear combination light socket and wire sub-assembly.


b.
B312223

Connect the connector.


c.

Engage the clamp.


Hide 81550S 2.INSTALL REAR SIDE MARKER LIGHT BULB (w/ Side Marker Light)

a.

Install the side marker light bulb to the rear combination light socket and wire sub-assembly.


b.
B314901

Turn the rear combination light socket and wire sub-assembly with the side marker light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.


Hide 81550L 3.INSTALL REAR TURN SIGNAL LIGHT BULB

a.

Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.


b.
B312225

Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.


Hide 81562A 4.INSTALL REAR COMBINATION LIGHT GASKET LH

a.
B370948

Install a new rear combination light gasket LH.

NOTICE:
·
B370949

Be sure to remove all the traces of the old rear combination light gasket from the rear combination light lens and body LH.

·

Install the rear combination light gasket LH so that it is securely seated and there is no displacement.

·

Do not reuse the removed packing. Be sure to install a new rear combination light gasket to prevent water ingress.