Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY
RM2090E _59 Vehicle Exterior _060711 LIGHTING (EXT) _0297804 REAR LIGHT ASSEMBLY G

LIGHTING (EXT)  REAR LIGHT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 81675 1.INSPECT BACK-UP LIGHT SOCKET AND WIRE

a.
B314144E03
2.063,1.385 2.344,1.792 true 0.156,0.104 0.438,0.448 0.281,0.344 10 false *a 2.406,1.771 2.563,1.948 0.156,0.177 10 false E

Apply battery voltage to the connector and check the light comes on.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Condition Specified Condition
Battery positive (+) → 1
Battery negative (-) → 3 (E)
Back-up light comes on


Text in Illustration
*a Component without harness connected
(Back-Up Light Socket and Wire)

If the result is not as specified, replace the bulb or the back-up light socket and wire.


Hide 81675 2.INSPECT BACK-UP LIGHT SOCKET AND WIRE (w/ Rear Fog Light)

a.
B314144E04
2.063,1.375 2.344,1.781 true 1.74,1.375 1.74,1.771 true 0.156,0.104 0.438,0.448 0.281,0.344 10 false *a 2.375,1.802 2.531,1.979 0.156,0.177 10 false E 1.698,1.802 1.854,1.979 0.156,0.177 10 false B

Apply battery voltage to the connector and check the light comes on.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Condition Specified Condition
Battery positive (+) → 2 (B)
Battery negative (-) → 3 (E)
Rear fog light comes on


Text in Illustration
*a Component without harness connected
(Back-Up Light Socket and Wire)

If the result is not as specified, replace the bulb or the back-up light socket and wire.