Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM2090E _59 Vehicle Exterior _060711 LIGHTING (EXT) _0297808 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 83910G 1.INSPECT CLOCK ASSEMBLY

a.
B312246E02
1.156,0.844 1.438,0.24 true 1.167,1.281 1.448,1.906 true 0.198,0.125 0.385,0.333 0.188,0.208 10 false *a 1.5,0.125 2.25,0.271 0.75,0.146 10 false HAZARD+ 1.51,1.854 2.26,2 0.75,0.146 10 false HAZARD-

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
7 (HAZARD+) - 14 (HAZARD-) Hazard warning signal switch off 10 kΩ or higher
7 (HAZARD+) - 14 (HAZARD-) Hazard warning signal switch on Below 1 Ω



b.

Apply battery voltage to the connector and check the LED illumination condition.

OK:
Condition Specified Condition
Battery positive (+) → 9
Battery negative (-) → 13
LED illuminates


Text in Illustration
*a Component without harness connected
(Clock Assembly)