89120A
1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR
Disconnect the D45 automatic light control sensor connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| D45-3 (CLTB) - D45-6 (CLTE) | Ignition switch OFF | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D45-6 (CLTE) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Automatic Light Control Sensor) |
If the result is not as specified, there may be a malfunction on the wire harness side.
Reconnect the D45 automatic light control sensor connector.
Connect an oscilloscope to the automatic light control sensor connector.
Check the waveform.
| Tester Connection | Tool Setting | Switch Condition | Specified Condition |
|---|---|---|---|
| D45-4 (CLTS) - D45-6 (CLTE) | 5 V/DIV., 5 ms./DIV | Ignition switch ON, light control switch in AUTO position | Correct waveform is as shown |
If the ambient light becomes brighter, width A becomes narrower.
If the result is not as specified, the automatic light control sensor may have a malfunction.
| *a | Component with harness connected
(Automatic Light Control Sensor) |