Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM2090E _59 Vehicle Exterior _060711 LIGHTING (EXT) _0297812 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89408C 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.
B309152E02
1,1.188 0.688,0.792 false 2.448,3.615 2.385,3.146 true 2.625,3.615 2.979,3.146 true 0.115,0.104 0.427,0.302 0.313,0.198 10 false *a 1.292,0.573 1.604,0.771 0.313,0.198 10 false *b 0.896,1.24 1.208,1.438 0.313,0.198 10 false *c 0.531,0.625 0.844,0.823 0.313,0.198 10 false *e 1.094,1.854 1.406,2.052 0.313,0.198 10 false *d 2.229,2.948 2.896,3.229 0.667,0.281 10 false OUT 2.906,2.948 3.344,3.198 0.438,0.25 10 false GND

Connect 3 dry cell batteries (1.5 V) in series.

NOTICE:

Do not use rechargeable batteries as they may not output a voltage of 1.5 V.



b.

Connect the positive (+) lead from the batteries to terminal 3 and the negative (-) lead from the batteries to terminal 1 (GND).


c.

Measure the voltage between terminals 2 (OUT) and 1 (GND) while slowly moving the link up and down.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (OUT) - 1 (GND) +45° (High) 4.5 V
2 (OUT) - 1 (GND) -15° (Normal) 2.5 V
2 (OUT) - 1 (GND) -45° (Low) 0.5 V


Text in Illustration
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly LH)
*b +45°
*c -15°
*d -45°
*e Reference line

If the result is not as specified, replace the rear height control sensor sub-assembly LH.