Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
RM2090E _59 Vehicle Exterior _060711 LIGHTING (EXT) _0297817 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM U

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  FAIL-SAFE CHART  


AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM


a.

The headlight leveling ECU assembly operates in fail-safe mode if an abnormal condition such as those listed below has been detected, and keep the last low beam status.

Item Abnormality Detection Condition Return Condition Warning Indicator
Height control sensor power source voltage Abnormal height control sensor power source voltage (4.6 V or less, or 6.25 V or more) is detected. Voltage of 4.61 to 6.24 V is detected Illuminated
Height control sensor signal voltage Abnormal height control sensor signal voltage (0.25 V or less, or 4.75 V or more) is detected. Voltage of 0.26 to 4.74 V is detected
IG power source voltage Abnormal high power source voltage (18.1 V or more) is detected. Voltage of 17.5 V or less is detected Not illuminated
Abnormal low power source voltage (9.0 V or less) is detected. Voltage of 9.3 V or more is detected for 0.1 seconds Not illuminated
Abnormal height control sensor signal while initialization Initialization is performed outside the valid range of the voltage for initialization. Initialization is successfully completed within the valid range of the voltage for initialization. Illuminated