Use the same procedure for RH and LH sides.
The procedure listed below is for LH side.
81150
1.INSTALL HEADLIGHT ASSEMBLY
Connect each connector.
Install the clip.
Engage the clamp.
Install the headlight assembly with the bolt.
52116A
2.INSTALL FRONT BUMPER SIDE SUPPORT LH
Install the bolt A.
Install the front bumper side support LH with the 3 bolts B.
Engage the 2 clamps to connect the wire harness.
52119A
3.INSTALL FRONT BUMPER COVER
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PREPARE VEHICLE FOR HEADLIGHT AIM ADJUSTMENT
6. PREPARE FOR HEADLIGHT AIMING
7.INSPECT HEADLIGHT AIMING
8.ADJUST HEADLIGHT AIMING