Use the same procedure for RH and LH sides.
The procedure listed below is for LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
52119A
2.REMOVE FRONT BUMPER COVER
52116A
3.REMOVE FRONT BUMPER SIDE SUPPORT LH
Disengage the 2 clamps to disconnect the wire harness.
Remove the bolt A.
Remove the 3 bolts B and the front bumper side support LH.
81175
4.REMOVE HEADLIGHT ASSEMBLY
Disconnect each connector.
Remove the clip.
Remove the bolt.
Disengage the claw to remove the headlight assembly.