86510
1.INSPECT HIGH PITCHED HORN ASSEMBLY (except CHINA)
Apply battery voltage and check the operation of the horn according to the table below.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2 |
High pitched horn sounds |
| *a | Component without harness connected
(High Pitched Horn Assembly) |
If the result is not as specified, replace the horn assembly.
86520
2.INSPECT LOW PITCHED HORN ASSEMBLY (for CHINA)
Check that the low pitched horn sounds when the battery voltage is applied between the terminal and the bracket.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1
Battery negative (-) → Body |
Low pitched horn sounds |
| *1 | Bracket |
| *a | Component without harness connected
(Low Pitched Horn Assembly) |
If the result is not as specified, replace the horn assembly.
86520
3.INSPECT LOW PITCHED HORN ASSEMBLY (except CHINA)
Check that the low pitched horn sounds when the battery voltage is applied between the terminal and the bracket.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1
Battery negative (-) → Body |
Low pitched horn sounds |
| *1 | Bracket |
| *a | Component without harness connected
(Low Pitched Horn Assembly) |
If the result is not as specified, replace the horn assembly.
86510
4.INSPECT HIGH PITCHED HORN ASSEMBLY (for CHINA)
Check that the high pitched horn sounds when the battery voltage is applied between the terminal and the bracket.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1
Battery negative (-) → Body |
High pitched horn sounds |
| *1 | Bracket |
| *a | Component without harness connected
(High Pitched Horn Assembly) |
If the result is not as specified, replace the horn assembly.