Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT FENDER GARNISH › from 2016.06
RM2090E _59 Vehicle Exterior _060713 EXTERIOR PANELS / TRIM _0297828 FRONT FENDER GARNISH A

EXTERIOR PANELS / TRIM  FRONT FENDER GARNISH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75602A 1.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH

a.

When reusing the removed front fender moulding sub-assembly:

i.

Using a piece of cloth, rub the remaining double-sided tape off the front fender moulding sub-assembly.


ii.

Using a non-residue solvent, clean the attachment surface.


iii.

Attach 6 clips to the front fender moulding sub-assembly.



b.

Clean the attachment surface.

i.

Using an infrared light, heat the double-sided adhesive tape remaining on the front fender panel.

Heating Temperature:
Item Temperature
Front Fender Panel 40 to 60°C (104 to 140°F)


CAUTION:

Do not burn yourself with the hot front fender panel or with the infrared light.


NOTICE:

Do not heat the front fender panel excessively.



ii.

Using a piece of cloth, rub the remaining double-sided tape off the front fender panel while it is hot from the infrared light.

NOTICE:

Installing the front fender moulding sub-assembly LH while any double-sided tape remains on the front fender panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.



iii.

Using a non-residue solvent, clean the attachment surface.



c.

Using an infrared light, heat the front fender moulding sub-assembly installation surface of the front fender panel and a front fender moulding sub-assembly.

Heating Temperature:
Item Temperature
Front Fender Panel 40 to 60°C (104 to 140°F)
Front Fender Moulding Sub-Assembly 20 to 30°C (68 to 86°F)


CAUTION:

Do not burn yourself with the hot front fender panel and front fender moulding sub-assembly or with the infrared light.


NOTICE:

Do not heat the front fender panel and front fender moulding sub-assembly excessively.



d.

Apply primer to the front fender moulding sub-assembly installation surface of the front fender panel and the front fender moulding sub-assembly

NOTICE:

Do not apply too much primer.



e.

Remove the released paper from a new No. 1 moulding tape and apply the tape to the front fender moulding sub-assembly.


f.

Install the front fender moulding sub-assembly with the 6 clips and the No. 1 moulding tape.