Use the same procedure for both the RH and LH sides.
The following procedure is for the LH side.
75602A
1.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH
Apply protective tape to the front fender panel in the area around the front fender moulding sub-assembly.
| *1 | Protective Tape |
Using an infrared light, heat the front fender panel and the front fender moulding sub-assembly.
| Item | Temperature |
|---|---|
| Front Fender Panel | 40 to 60°C (104 to 140°F) |
| Front Fender Moulding Sub-Assembly | 20 to 30°C (68 to 86°F) |
Do not burn yourself with the hot front fender panel and front fender moulding sub-assembly or with the infrared light.
Do not heat the front fender panel and front fender moulding sub-assembly excessively.
Insert piano wire between the front fender panel and the front fender moulding sub-assembly.
| *1 | Piano Wire |
| *2 | Wooden Block |
Be careful of the boss positions.
Tie objects that can serve as handles (for example, wooden blocks) to the piano wire ends.
Pull the piano wire and scrape off the double-sided tape that holds the front fender moulding sub-assembly to the front fender panel.
Be careful not to damage the front fender panel.
Using a moulding remover, disengage the 6 clips and remove the front fender moulding sub-assembly.
If reusing the garnish, take care not to damage the front fender moulding sub-assembly.
Be careful not to damage the vehicle body.