64711
1.REMOVE LUGGAGE COMPARTMENT FLOOR MAT
58387
2.REMOVE REAR FLOOR FINISH PLATE
64429F
3.REMOVE LUGGAGE COMPARTMENT TRIM BOX
64722
4.REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH
52159
5.REMOVE REAR BUMPER COVER
Disconnect the rear light assembly connector.
Disengage the clamp and disconnect the wire harness.
Disengage the grommet and pull out the wire harness.
Remove the 2 screws.
Put protective tape around the rear bumper cover.
| *1 | Protective Tape |
Using a clip remover, remove the 6 clips.
Remove the clip.
Use the same procedure for the RH and LH sides.
Disengage the 8 claws as shown in the illustration.
Use the same procedure for the RH and LH sides.
Disengage the 3 guides and remove the rear bumper cover.