Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2014.05
RM2090E _53 Suspension _060682 TIRE PRESSURE MONITORING _0297611 TIRE PRESSURE WARNING SYSTEM Y

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the tire pressure warning system.

·

Make sure that the wireless door lock control system has exited diagnostic mode before performing the following procedure.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Interview the customer to confirm the trouble.

HINT:

It is important to collect as much specific information as possible from the customer to allow for a quick repair.



Result:
Proceed to
NEXT



NEXT

3.ADJUST TIRE PRESSURE*
3.ADJUST TIRE PRESSURE*
a.

Turn the ignition switch off.


b.

Set all tire pressures to the specified value.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>PRECAUTION


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


f.

Read the "ID Tire Inflation Pressure" values.


g.

Check the Data List.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST

HINT:
·

It takes a few minutes to display the updated tire pressure data.

·

If the problem is that the tire pressure decreases, wait until all of the tire pressure data is received by the ECU. If the data is received, the tire pressure warning light will go off.




Result:
Condition Proceed to
Tire pressure warning light remains on A
Tire pressure warning light goes off B



A

4.CHECK ECU CONNECTED TO CAN BUS*

B

11.CONFIRMATION TEST*
4.CHECK ECU CONNECTED TO CAN BUS*
a.

Check the ECUs connected to the CAN bus.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
No malfunction appears A
Malfunction appears B



A

5.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)*

B

5.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)*

Result:
Result Proceed to
CAN system DTC is not output A
CAN system DTC is output B



A

6.CHECK FOR DTC*

B

6.CHECK FOR DTC*

Result:
Result Proceed to
DTC is output A
DTC is not output B



A

7.DTC CHART

B

8.PROBLEM SYMPTOMS TABLE
7.DTC CHART

Result:
Proceed to
NEXT



NEXT

10.REPAIR OR REPLACE
8.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
NEXT



NEXT

9.CIRCUIT INSPECTION*
9.CIRCUIT INSPECTION*

Result:
Proceed to
NEXT



NEXT

10.REPAIR OR REPLACE
10.REPAIR OR REPLACE
a.

Repair or replace parts based on the diagnosis result.


Result:
Proceed to
NEXT



NEXT

11.CONFIRMATION TEST*
11.CONFIRMATION TEST*
a.

Check the Data List to confirm that the tire inflation pressure has been received.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST


Result:
Proceed to
NEXT



NEXT

END