Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System)
RM2090E _58 Vehicle Interior _060696 DOOR LOCK _0297670 WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System) Y

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.

Use this procedure to troubleshoot the wireless door lock control system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC*
3.CHECK FOR DTC*

b.

Clear the DTCs.


c.

Recheck for DTCs. Based on the DTCs output above, try to force output of the same CAN communication system DTC or wireless door lock control system DTC by simulating the symptoms indicated by the DTC.


Result:
Result Proceed to
DTC is not output A
CAN communication system DTC is output B
Wireless door lock control system DTC is output C



A

4.PROBLEM SYMPTOMS TABLE

B

C

4.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

5.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

6.REPAIR OR REPLACE
6.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END