Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
Remove the 2 bolts and separate the rear disc brake caliper assembly LH.
| *A | for Floating Type Caliper |
| *B | for Opposed Type Caliper |
Hang the rear disc brake cylinder assembly LH with wire or equivalent.
42431
3.REMOVE REAR DISC
Put matchmarks on the rear disc and the rear axle hub.
| *a | Matchmark |
Release the parking brake and remove the rear disc.
If the disc cannot be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.
| *a | Expand | *b | Contract |
46550E
4.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Front Side)
Using SST, remove the parking brake shoe return tension spring (for front side).
46550E
5.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Rear Side)
Using SST, remove the parking brake shoe return tension spring (for rear side).
47613D
6.REMOVE PARKING BRAKE SHOE STRUT COMPRESSION SPRING
Using SST, remove the parking brake shoe strut compression spring.
47447D
7.FIX PARKING BRAKE SHOE HOLD DOWN COMPRESSION SPRING (for Front Side)
Using SST, remove the brake shoe hold down compression spring (for front side).
Hold the parking brake shoe hold down spring pin with your finger.
47447C
8.REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for Front Side)
Remove the parking brake shoe hold down spring pin (for front side).
47614
9.REMOVE PARKING BRAKE SHOE STRUT LH
Pull the parking brake shoe towards the front of the vehicle by hand as shown in the illustration.
Remove the parking brake shoe strut LH.
| *1 | Parking Brake Shoe Strut LH |
47447D
10.REMOVE PARKING BRAKE SHOE HOLD DOWN COMPRESSION SPRING (for Rear Side)
Using SST, remove the brake shoe hold down compression spring (for rear side).
Use the service hole to hold the parking brake shoe hold down spring pin with your finger.
47447C
11.REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for Rear Side)
Remove the parking brake shoe hold down spring pin (for rear side).
47406A
12.REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET
Expand the parking brake shoe outward by hand and pull downward to separate them from the parking brake plate.
Remove the parking brake shoe adjusting screw set.
04495A
13.REMOVE PARKING BRAKE SHOE KIT
Remove the parking brake shoe kit.
46550G
14.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING
Remove the parking brake shoe return tension spring.
47612
15.REMOVE PARKING BRAKE SHOE LEVER LH
Using needle-nose pliers, remove the parking brake shoe lever LH from the No. 3 parking brake cable assembly as shown in the illustration.
46550C
16.REMOVE PARKING BRAKE SHOE TYPE C WASHER
Widen and remove the parking brake shoe type C washer from the parking brake shoe as shown in the illustration.
46550D
17.REMOVE PARKING BRAKE SHOE WAVE WASHER
Remove the parking brake shoe wave washer.
46550B
18.REMOVE PARKING BRAKE SHOE PIN
Remove the parking brake shoe pin.