Home › Brake › BRAKE (REAR) › REAR BRAKE (for Opposed Type Caliper) › from 2017.03
RM2090E _54 Brake _060687 BRAKE (REAR) _0313979 REAR BRAKE(for Opposed Type Caliper) A

BRAKE (REAR)  REAR BRAKE(for Opposed Type Caliper)  REASSEMBLY  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 47547C 1.TEMPORARILY INSTALL REAR DISC BRAKE BLEEDER PLUG

a.

Temporarily install the 2 rear disc brake bleeder plugs to the rear disc brake cylinder assembly LH.


Hide 31478C 2.INSTALL REAR DISC BRAKE BLEEDER PLUG CAP

a.

Install the 2 rear disc brake bleeder plug caps to the rear disc brake bleeder plugs.


Hide 3.INSTALL PISTON SEAL

a.
C364393

Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new piston seals and install them into the groove of the rear disc brake cylinder assembly LH.

Text in Illustration
V100144

Lithium Soap Base Glycol Grease


Hide 47731B 4.INSTALL REAR DISC BRAKE PISTON

a.
C262307E04
2.302,1.031 2.708,1.031 false 0.917,0.375 1.323,0.375 false 1.229,2.615 1.229,2.229 1.229,2.229 1.74,2.229 false 1.75,3.771 2.198,3.771 false 1.396,0.292 1.708,0.49 0.313,0.198 10 false *1 2.771,0.958 3.083,1.156 0.313,0.198 10 false *2 1.792,2.146 2.104,2.344 0.313,0.198 10 false *1 2.25,3.708 2.563,3.906 0.313,0.198 10 false *2

Apply a light layer of lithium soap base glycol grease to a new cylinder boot, and put it on the disc brake piston as shown in the illustration.

Text in Illustration
*1 Piston
*2 Cylinder Boot
V100144

Lithium soap base glycol grease


b.

Fit the seal section of the cylinder boot into the groove of the rear disc brake cylinder assembly LH.

NOTICE:

Securely fit the seal section of the cylinder boot.



c.

Push in the piston by hand and fit the seal section of the boot into the groove of the rear disc brake piston.

NOTICE:

Securely fit the seal section of the cylinder boot.