1.REMOVE CLAMP
Remove the screw.
Remove the clamp from harness.
2.REMOVE MAGNET CLUTCH ASSEMBLY
Fix the cooler compressor assembly in a vise between aluminum plates.
Do not tighten the vise more than necessary.
Hold the compressor assembly in place to prevent it from falling out and being damaged.
| *a | Magnet Clutch Stopper |
Using a magnet clutch stopper to remove the bolt and remove the magnet clutch hub.
When removing the magnet clutch hub, be careful not to drop the magnet clutch washer.
Using SST, remove the snap ring (for magnet clutch pulley) and magnet clutch pulley.
Using SST, remove the snap ring (for magnet clutch stator) and magnet clutch stator.