1.INSTALL MAGNET CLUTCH ASSEMBLY
Align the protrusion A of the magnet clutch stator with the cutout B of the compressor assembly.
Using SST, install a new snap ring (for magnet clutch stator) to secure the magnet clutch stator.
Make sure to use a new snap ring and install it with the chamfered side facing the front of the vehicle.
Using SST, install a new snap ring (for magnet clutch pulley) to secure the magnet clutch pulley.
Make sure to use a new snap ring and install it with the chamfered side facing the front of the vehicle.
| *a | Magnet Clutch Stopper |
Using a magnet clutch stopper, Install the magnet clutch hub with the bolt.
2.INSTALL CLAMP
| *a | 95 to 125 mm (3.74 to 4.92 in.) |
Install the clamp to harness as show in the illustration.
Install the clamp to compressor assembly with the screw.