Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014963 CRANKSHAFT POSITION SENSOR A

K3-VE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 51441D 1.REMOVE ENGINE UNDER COVER (for Half Cover Type)

Hide 51441 2.REMOVE NO. 1 ENGINE UNDER COVER (for Full Cover Type)

Hide 51443 3.REMOVE REAR ENGINE UNDER COVER (for Full Cover Type)

Hide 11301K 4.REMOVE CRANKSHAFT POSITION SENSOR

A135731

a.

Disconnect the crankshaft position sensor connector.


b.

Remove the bolt and crankshaft position sensor.