The ECM intercommunicates with the TCM and the combination meter assembly through the Controller Area Network (CAN).
If the ECM cannot communicate with the TCM and/or the combination meter assembly, the ECM sets a DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0001 | High Speed CAN Communication Bus | No communication between ECM, combination meter and TCM for 2 second or more
(1 trip detection logic) |
·
Open or short in TCM, ECM and combination meter circuit ·
TCM ·
Combination meter assembly ·
ECM |
Comes on | DTC stored |
| U0101 | Lost Communication with TCM | Either of following condition met:
(1 trip detection logic) ·
No communication from TCM (reception) for 1 second or more ·
No communication from ECM (transmission) for 0.3 seconds or more |
·
Open or short in TCM and ECM circuit ·
TCM ·
ECM |
Comes on | DTC stored |
| U0156 | Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) | No communication from combination meter (reception) for 1 second or more
(1 trip detection logic) |
·
Open or short in combination meter and ECM circuit ·
Combination meter assembly ·
ECM |
Comes on | DTC stored |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs.
Click hereEngine / Hybrid System>K3-VE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR
Start the engine.
Drive the vehicle.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
|---|---|
| U0001, U0101, or U0156 | A |
| No output | B |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B