Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › SFI SYSTEM › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014971 SFI SYSTEM C

K3-VE ENGINE CONTROL  SFI SYSTEM  P0603  Internal Control Module Keep Alive Memory (KAM) Error  


DESCRIPTION

The transponder key computer assembly (immobiliser ECU) ensures security by controlling the START/END of the communication of matching codes with the ECM. It does so in accordance with ignition ON/OFF status and the immobiliser SET/ UNSET status. If the communication cannot be matched due to a malfunction in the ECM, a DTC is recorded.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0603 Internal Control Module Keep Alive Memory (KAM) Error Rolling codes cannot be overwritten into ECM
(1 trip detection logic)
ECM - DTC stored

WIRING DIAGRAM

A268106E04
0.292,3.75 1.031,4.094 0.74,0.344 10 E58 0.281,3.927 3.094,4.458 2.813,0.531 10 TRANSPONDER KEY ECU 6.208,3.771 6.677,4.125 0.469,0.354 10 E3 6.208,3.948 7.135,4.385 0.927,0.438 10 ECM 0.802,1.458 1.469,1.823 0.667,0.365 10 SIO2 0.958,2.042 1.385,2.521 0.427,0.479 10 E 1.25,1.365 1.615,1.771 0.365,0.406 10 9 1.25,1.938 1.635,2.271 0.385,0.333 10 14 6.042,1.469 6.875,1.938 0.833,0.469 10 SIO2 5.677,1.375 6.104,1.854 0.427,0.479 10 32

PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine / DTC.

Powertrain > Engine > Trouble Codes
50001 206

e.

Read DTCs.

HINT:

If P0603 is detected, this indicates that the engine computer is malfunctioning. Replace the engine control computer.


Result:
Result Proceed to
No output A
P0603 (for LHD) B
P0603 (for RHD) C




A

B

C